Industrial Indicators for Wollastonite Ore
Release time:
2013-11-07
Source:
Wollastonite The industrial indicators for ore mainly include the required grade of wollastonite and the chemical composition of the ore. Due to differences in geological conditions of deposits and varying levels of mining technology across different regions, industrial sectors both domestically and internationally have slightly different requirements for the grade of wollastonite deposits. Generally, a wollastonite grade of 60% or higher is considered a rich ore; a grade between 40% and 60% is classified as medium-grade ore; and a grade between 30% and 40% is regarded as a poor ore. The following range of grades is considered appropriate for wollastonite deposits:
Industrial grade: Wollastonite grade in the ore ≥ 50%;
Cut-off grade: Wollastonite grade in ore ≥ 30%;
Grade I: Wollastonite content in the ore ≥ 70%;
Class II product; wollastonite grade in the ore: 50-70%;
Grade III: Wollastonite content in the ore ≥ 30–50%.
Silicite deposits with an average grade below 60% must undergo beneficiation before they can be utilized. When the silicite grade is 30%, separate mining would not be economically viable; however, integrated utilization could be considered.
The grade requirements for wollastonite often depend on its application area. In the general ceramics industry, the concentrate is typically required to have a wollastonite grade of at least 80%, with calcite content not exceeding 10%. For the coatings industry, even richer concentrates are needed, with a wollastonite grade of no less than 90% and a standard whiteness of at least 75%. In U.S. wollastonite beneficiation products, the FeO3 content is below 1%, and the calcite content is below 10%. The typical grade requirement for wollastonite in ore is generally no less than 50%.
Used by the Soviet ceramic industry Wollastonite Concentrate with a grade of no less than 80%, a calcite content of no more than 5%, and a ferro-titanium oxide content of less than 0.8%.